FFT coefficients question

Question

I'm a software engineer working on DSP for the first time.

I'm successfully using an FFT library that produces frequency spectrums. I also understand how the FFT works in terms of its inputs and outputs, in particular the contents of the two output arrays:

Now, my problem is that I'm reading some new research reports that suggest that I extract: "the energy, variance, and sum of FFT coefficients".

1. What are the 'FFT coefficients'? Are those the values of the Real and Imaginary arrays shown above, which (from my understanding) correspond to the amplitudes of the constituent cosine and sine waves?

2. What is the 'energy' of the FFT coefficients? Is that terminology from statistics or from DSP?

Answer 1

The real and imaginary arrays, when put together, can represent a complex array. Every complex element of the complex array in the frequency domain can be considered a frequency coefficient, and has a magnitude ( sqrt(R*R + I*I) ). Parseval's theorem says that the sum of all the Frequency domain complex vector magnitudes (squared) is equal to the energy of the time domain signal (which may require a scaling factor involving the FFT length, depending on your particular DFT/FFT library implementation).

One example of a time domain signal is voltage on a wire, which when measured in Volts times Amps into Ohms represents power, or over time, energy. Probably the word "energy" in the strictly numerical case is derived from historical usage from physics or engineering, where the numbers meant something that could burn your fingers.

Answer 2

1. You are correct. FFT coefficients are the signal values in the frequency domain.
2. "Energy" is the square modulus of the coefficients. The total energy (sum of square modulus of all values) in either time or frequency domain is the same (see Parseval's Theorem).