Using a specific network interface for a socket in

Question

Is there a reliable way in Windows, apart from changing the routing table, to force a newly created socket to use a specific network interface? I understand that bind() to the interface's IP address does not guarantee this.

Answer 1

(Ok second time lucky..)

FYI there's another question here perform connect() on specific network adapter along the same lines...

According to The Cable Guy

Windows XP and Windows Server® 2003 use the weak host model for sends and receives for all IPv4 interfaces and the strong host model for sends and receives for all IPv6 interfaces. You cannot configure this behavior. The Next Generation TCP/IP stack in Windows Vista and Windows Server 2008 supports strong host sends and receives for both IPv4 and IPv6 by default on all interfaces except the Teredo tunneling interface for a Teredo host-specific relay.

So to answer your question (properly, this time) in Windows XP and Windows Server 2003 IP4 no, but for IP6 yes. And for Windows Vista and Windows 2008 yes (except for certain circumstances).

Also from http://www.codeguru.com/forum/showthread.php?t=487139

On Windows, a call to bind() affects card selection only incoming traffic, not outgoing traffic. Thus, on a client running in a multi-homed system (i.e., more than one interface card), it's the network stack that selects the card to use, and it makes its selection based solely on the destination IP, which in turn is based on the routing table. A call to bind() will not affect the choice of the card in any way.

It's got something to do with something called a "Weak End System" ("Weak E/S") model. Vista changed to a strong E/S model, so the issue might not arise under Vista. But all prior versions of Windows used the weak E/S model.

With a weak E/S model, it's the routing table that decides which card is used for outgoing traffic in a multihomed system.

See if these threads offer some insight:

"Local socket binding on multihomed host in Windows XP does not work" at http://www.codeguru.com/forum/showthread.php?t=452337

"How to connect a port to a specified Networkcard?" at http://www.codeguru.com/forum/showthread.php?t=451117. This thread mentions the CreateIpForwardEntry() function, which (I think) can be used to create an entry in the routing table so that all outgoing IP traffic with a specified server is routed via a specified adapter.

"Working with 2 Ethernet cards" at http://www.codeguru.com/forum/showthread.php?t=448863

"Strange bind behavior on multihomed system" at http://www.codeguru.com/forum/showthread.php?t=452368

Hope that helps!