Understanding Direct Mapped Cache

Question

I'm trying to understand direct mapped cache, but it is a very complex concept. I have written what I think I understand so far, but I am unsure whether I am correct or not. Can somebody please verify if the explanation below is correct?

E.g, for a made up computer, just for the sake of this question, there 1024 memory locations (cells) in the RAM. This equals 2^10 so the address for each of these memory locations must be 10 bits long.

The CPU is asked to get data from the RAM memory address 1100100111. However the CPU doesn't access the data directly from this memory address in the RAM. The RAM stores this data to cache memory and then the CPU gets the data from the cache memory.

There are different ways of doing this, one being direct mapped cache. The cache memory and ram memory are divided up into blocks, where the number of cells in the blocks in each memory must be the same. The number of blocks in the RAM and cache must also be a power of 2.

In this example lets say there are 2^6 = 64 blocks in the RAM, so there are 1024/64 = 16 cells in each block. Lets say there are 2^2 = 4 blocks in the cache, so the cache has 64 cells. The "6" and "2" in the exponents of these numbers are important later on.

Because the The number of blocks in the RAM and cache is a power of 2, it makes the calculations easy. In our address 1100100111 the last 6 bits mark the offset 100111 (the 6 comes from the fact that 2^6 = 64), and the remaining 4 bits 1100 mark the RAM block number the data is stored in. Within this block number are two other important numbers. First the cache block number; this is the cache block that that RAM block would store to. This is the first 2 bits after the offset, so it will be 00 (The 2 comes from the fact that There are 2^2 = 4 blocks in the cache). The remaining 2 numbers in the address mark the tag. This will be 11.

So when the CPU is asked to get data from memory address 1100100111 it will look for this data in cache block number 00. It will compare the tag of the address 11 to the tag saved in the cache, which is a separate piece of memory used to store information about where from the RAM the data has come from. If the tags are the same this is a hit and this is the data the CPU is looking for. If the tag of the address and the tag in the memory are different, then this is a miss, and the data isn't stored in the cache.

If this is the case, the cache controller will get the data from block number 1100 in the RAM and store it in the cache block number 00, and update the tag in this block to 11. The CPU can now get the data in this block.

Is this all correct? I need to understand this before I can start to try and understand associative and set associative memory.

Thanks!

Answer 1

You have the right idea, but your numbers went wrong somewhere. In your example you have a direct-mapped cache of 4 blocks/lines of 16 bytes/cells each. The address 1100100111 will be divided up as follows. You use the least significant four bits 0111 as the offset because it refers to which cell of a particular block you want. I think you accidentally included the block number as part of the offset. Anyway, the next least significant two bits 10 will be the block number and the most significant four bits 1100 will be the tag.

Your understanding seems to be fine. One thing more that is necessary is a bit to indicate if the cache block is valid or not. Good luck with the associative stuff!