Signal EOF in mac osx terminal

Question

I am stumped by the 1.5.2 question in K&R. I googled for sometime and found out that i have to supply the EOF input after entering the characters.

long nc = 0;

while (getchar() != EOF)
    ++nc;
printf("%ld\n", nc);

return 0;

I tried both commnad-D and control-D as EOF inputs but nothing worked. Any Idea how to supply the EOF for mac osx?

Answer 1

If you want to see what EOF is set as in your terminal, you can type

stty all

on my mac, this gives the output -

speed 9600 baud; 24 rows; 80 columns;
lflags: icanon isig iexten echo echoe -echok echoke -echonl echoctl
    -echoprt -altwerase -noflsh -tostop -flusho pendin -nokerninfo
-extproc
iflags: -istrip icrnl -inlcr -igncr ixon -ixoff ixany imaxbel iutf8
-ignbrk brkint -inpck -ignpar -parmrk
oflags: opost onlcr -oxtabs -onocr -onlret
cflags: cread cs8 -parenb -parodd hupcl -clocal -cstopb -crtscts -dsrflow
-dtrflow -mdmbuf
discard dsusp   eof     eol     eol2    erase   intr    kill    lnext   
^O      ^Y      ^D      <undef> <undef> ^?      ^C      ^U      ^V      
min     quit    reprint start   status  stop    susp    time    werase  
 1       ^\      ^R      ^Q      ^T      ^S      ^Z      0       ^W     

You can see four lines up from the bottom, three cells in eof is ^D.

There's a fuller description here which is where I found the information.

Answer 2

I just figured it out. You have to press Ctrl+D+D. Hold the control down and press D twice. I have to say what a weird key sequence.

Answer 3

By default, OS X (formerly Mac OS X) terminals recognize EOF when Ctrl-D is pressed at the beginning of a line.

In detail, the actual operation is that, when Ctrl-D is pressed, all bytes in the terminal’s input buffer are sent to the running process using the terminal. At the start of a line, no bytes are in the buffer, so the process is told there are zero bytes available, and this acts as an EOF indicator.

This procedure doubles as a method of delivering input to the process before the end of a line: The user may type some characters and press Ctrl-D, and the characters will be sent to the process immediately, without the usual wait for enter/return to be pressed. After this “send all buffered bytes immediately” operation is performed, no bytes are left in the buffer. So, when Ctrl-D is pressed a second time, it is the same as the beginning of a line (no bytes are sent, and the process is given zero bytes), and it acts like an EOF.

You can learn more about terminal behavior by using the command “man 4 tty” in Terminal. The default line discipline is termios. You can learn more about the termios line discipline by using the command man termios.