What is EOF in the C programming language?

Question

How do you get to see the last print? In other words what to put in for EOF? I checked the definitions and it says EOF is -1.

And if you enter Ctrl-D you won't see anything.

#include <stdio.h>

int main() {
 int c;
 while((c = getchar() != EOF)) {
  printf("%d\n", c);
 }
 printf("%d - at EOF\n", c);
}

Answer 1

On Linux systems and OS X, the character to input to cause an EOF is Ctrl-D. For Windows, it's Ctrl-Z.

Depending on the operating system, this character will only work if it's the first character on a line, i.e. the first character after an Enter. Since console input is often line-oriented, the system may also not recognize the EOF character until after you've followed it up with an Enter.

And yes, if that character is recognized as an EOF, then your program will never see the actual character. Instead, a C program will get a -1 from getchar().

Answer 2

nput from a terminal never really "ends" (unless the device is disconnected), but it is useful to enter more than one "file" into a terminal, so a key sequence is reserved to indicate end of input. In UNIX the translation of the keystroke to EOF is performed by the terminal driver, so a program does not need to distinguish terminals from other input files. By default, the driver converts a Control-D character at the start of a line into an end-of-file indicator. To insert an actual Control-D (ASCII 04) character into the input stream, the user precedes it with a "quote" command character (usually Control-V). AmigaDOS is similar but uses Control-\ instead of Control-D.

In Microsoft's DOS and Windows (and in CP/M and many DEC operating systems), reading from the terminal will never produce an EOF. Instead, programs recognize that the source is a terminal (or other "character device") and interpret a given reserved character or sequence as an end-of-file indicator; most commonly this is an ASCII Control-Z, code 26. Some MS-DOS programs, including parts of the Microsoft MS-DOS shell (COMMAND.COM) and operating-system utility programs (such as EDLIN), treat a Control-Z in a text file as marking the end of meaningful data, and/or append a Control-Z to the end when writing a text file. This was done for two reasons:

1. Backward compatibility with CP/M. The CP/M file system only recorded the lengths of files in multiples of 128-byte "records", so by convention a Control-Z character was used to mark the end of meaningful data if it ended in the middle of a record. The MS-DOS filesystem has always recorded the exact byte-length of files, so this was never necessary on MS-DOS.

2. It allows programs to use the same code to read input from both a terminal and a text file.

Answer 3

int c;

while((c = getchar())!= 10)
{
    if( getchar() == EOF )
        break;

     printf(" %d\n", c);
}