Unit testing of Spring Boot Actuator endpoints not

问题:

recently I changed my spring boot properties to define a management port. In doing so, my unit tests started to fail :(

I wrote a unit test that tested the /metrics endpoint as follows:

@RunWith (SpringRunner.class)
@DirtiesContext
@SpringBootTest
public class MetricsTest {

    @Autowired
    private WebApplicationContext context;

    private MockMvc mvc;

    /**
     * Called before each test.
     */
    @Before
    public void setUp() {
        this.context.getBean(MetricsEndpoint.class).setEnabled(true);
        this.mvc = MockMvcBuilders.webAppContextSetup(this.context).build();
    }

    /**
     * Test for home page.
     *
     * @throws Exception On failure.
     */
    @Test
    public void home()
            throws Exception {
        this.mvc.perform(MockMvcRequestBuilders.get("/metrics"))
                .andExpect(MockMvcResultMatchers.status().isOk());
    }
}        

Previously this was passing. After adding:

management.port=9001

The tests started failing with:

home Failed: java.lang.AssertionError: Status expected: <200> but was: <404>

I tried changing the @SpringBootTest annotation with:

@SpringBootTest (properties = {"management.port=<server.port>"})

Where is the number used for the server.port. This didn't seem to make any difference.

So then changed the management.port value in the property file to be the same as the server.port. Same result.

The only way to get the test to work is remove the management.port from the property file.

Any suggestions/thoughts ?

Thanks

回答1:

Did you try adding the following annotation to your test class?

@TestPropertySource(properties = {"management.port=0"})

Check the following link for reference.

回答2:

Had the same issue, you just have to make the management.port null by adding this in your application-test.properties (set it to empty value)

management.port=

Make sure you use the test profile in your JUnit by annotating the class with

@ActiveProfiles("test")

回答3:

Isn't there an error in the property name? Shouldn't be @TestPropertySource(properties = {"management.server.port=..."}) instead of @TestPropertySource(properties = {"management.port=.."})

回答4:

For Spring boot test we need to specify the port it needs to connect to.

By default, it connects to server.port which in case of actuators is different.

This can be done by

@SpringBootTest(properties = "server.port=8090")

---

in application.properties we specify the management port as below

...
management.port=8090
...

回答5:

Try using

@SpringBootTest(properties = {"management.port="})

Properties defined in the @SpringBootTest annotation have a higher precedence than those in application properties. "management.port=" will "unset" the management.port property.
This way you don't have to worry about configuring the port in your tests.