Can SendMessage return early if the receiving thre

问题:

How precisely does windows decide that SendMessage should return- that is, how does it decide the receiving thread has finished processing the sent message?

Detailed scenario: I've got thread A using SendMessage to send a thread to thread B. Obviously SendMessage doesn't return until thread B finishes processing the message. Thread B pops up a dialog box and starts pumping messages. In my scenario, there is a WM_KILLFOCUS message on the queue which gets pumped by thread B. This results is a WM_COMMAND message on thread B. Thread B passes this WM_COMMAND message to the default window proc. When it does this, SendMessage returns back to thread A, even though the original message hasn't finished processing yet! What is going on? It looks like somehow the default window proc is confusing windows into thinking the original sent message is finished.

So are there known scenarios where pumping messages and calling the default window proc can trick SendMessage into returning?

Thanks! Phil

回答1:

As long as processing of the message has started, the WindowProc processing the interthread message can call ReplyMessage to allow the calling thread to continue while processing continues.

回答2:

Since SendMessage has a return value, it is always after the message is processed.

PostMessage on the other hand will not wait for the message to be processed.

From MSDN on SendMessage:

The SendMessage function calls the window procedure for the specified window and does not return until the window procedure has processed the message.

There is no case where it will return before the message is processed.

回答3:

From the MSDN, it sounds like that the problem may be that displaying a dialog box in thread B may cause deadlocks. See Message Deadlocks.

---

Possibly it is because the message received by thread A was a nonqueued message. From MSDN:

However, the sending thread will process incoming nonqueued messages while waiting for its message to be processed. To prevent this, use SendMessageTimeout with SMTO_BLOCK set. For more information on nonqueued messages, see Nonqueued Messages.

回答4:

It sounds as if your original SendMessage has NOT returned but rather than the WindowProc in thread A has been called during the processing of the message sent. There is no requirement that a message handler must refrain from calling SendMessage in response to receipt of a message.

You should be able to see the original call to SendMessage in your callstack at the point where you receive the WM_COMMAND that you sent in response to the focus change message.