Network UDP broadcast design?

问题:

I am working on a C++ server/.NET client applications couple in which my server (which runs the c++ on linux) broadcasts a message to show it's alive to the whole network and my .NET program listens for packets and parses to get the uptime of the server.

As I have read, to send a regular UDP broadcast to the broadcast address, I simply have to send a packet to 192.168.0.255 (in my case 192.168.2.255) or 255.255.255.255. Is this right? Can I use the same port address? Are there any other necessities?

I understand the fact that if my .NET program listens on that particular address it is possible to receive packets from other applications than my C++ server program. Is there any method of "signing" the packet on the C++ server-side in order for my .NET program to read the header of the packet and see that it is (almost) the one I am looking for?

回答1:

Regardless of the language you are using, here is my answer:

Regarding the broadcast IP addresses, both addresses are broadcast addresses but the limited broadcast address (which is 255.255.255.255) won't be forwarded by routers. It is better to use the subnet-directed broadcast address (192.168.2.255).

In order to send/receive a broadcast address, you need to define your broadcast address (broadcast IP address and port number). For example: 192.168.2.255 and port number 3000. The client applications (the senders) MUST enable SO_BROADCAST socket option as follows:

int enabled = 1;
setsockopt(sockfd, SOL_SOCKET, SO_BROADCAST, &enabled, sizeof(enabled));

where sockfd is the socket descriptor.

The server application will listen on a specific port number (port 3000). Normally, the server will respond to each request using unicast message.

There will be no conflict as long as no application is listening on the same port number. Your server will not run if another application is listening on the same port unless you enabled SO_REUSEADDRESS socket option. However, if there is a conflict, then your signiture is depending on your protocol (message format). So, check the message format and reject the message if it does not follow the message format defined by your application protocol.

For client applications, the received packet is unicast (unless you have another design). So, no conflict at this side.

回答2:

You also have to enable the SO_BROADCAST socket option in C++ to send broadcast traffic, or you'll get a permission denied error:

int broadcastPermission = 1;
setsockopt(socketDescriptor, SOL_SOCKET, SO_BROADCAST, (void*)&broadcastPermission, sizeof(broadcastPermission))

回答3:

If your .NET program listens for broadcast traffic, it will receive any and all broadcast traffic on the network sent on that port, including traffic not sent by your server. You could put a "marker" in the payload of the broadcast messages sent by your server. This way, your .NET program could distinguish which ones it cares about.

Beyond that, I would recommend using multicast instead of broadcast. Broadcast traffic is usually restricted to hosts on the same subnet. In layman's terms, if you have a router in your network, a host on side A of the router will not see broadcast traffic sent by a host on side B (and vice versa) because the router "blocks" it. Routers will almost always forward multicast traffic if a host has joined the multicast group.