postgresql error PANIC: could not locate a valid c

问题:

When I load up the postgres server (v9.0.1) i get a panic that prevents it from starting:

PANIC: could not locate a valid checkpoint record

How can I fix this?

回答1:

It's looking for a checkpoint record in the transaction log that probably doesn't exist or is corrupted. You can determine if this is the case by running:

# Postgres < 10.0
pg_resetxlog DATADIR

# Postgres >= 10.0
pg_resetwal DATADIR

If the transaction log is corrupt, you'll see a message like:

The database server was not shut down cleanly. Resetting the transaction log might cause data to be lost. If you want to proceed anyway, use -f to force reset.

You can then follow the instructions and run with -f to force the update:

# Postgres < 10.0
pg_resetxlog -f DATADIR 

# Postgres >= 10.0
pg_resetwal -f DATADIR

That should reset the transaction log, however it could leave your database in an indeterminate state as explained in the PostgreSQL documentation on pg_resetxlog:

If pg_resetxlog complains that it cannot determine valid data for pg_control, you can force it to proceed anyway by specifying the -f (force) switch. In this case plausible values will be substituted for the missing data. Most of the fields can be expected to match, but manual assistance might be needed for the next OID, next transaction ID and epoch, next multitransaction ID and offset, and WAL starting address fields. These fields can be set using the switches discussed below. If you are not able to determine correct values for all these fields, -f can still be used, but the recovered database must be treated with even more suspicion than usual: an immediate dump and reload is imperative. Do not execute any data-modifying operations in the database before you dump, as any such action is likely to make the corruption worse.

回答2:

I'm running 9.1.7 and i find ran the following successfully:

/usr/lib/postgresql/9.1/bin/pg_resetxlog -f /var/lib/postgresql/9.1/main

Your final argument to the pg_resetxlog command should be the location on disk where postgres stores your database data.

回答3:

As indicated here pg_resetxlog should not be run. The answers that refer to this is bad advice. Assuming the error occured in a context of copy/replication instance, the link provides a more succinct way of doing copy/replication with pg_basebackup

回答4:

Do you do continuous archiving? If you are backing up at the time, you may find it more prudent to remove backup_label. pg_resetxlog is a severe thing.

回答5:

just like the log saying : could not locate a valid checkpoint record.Postgres can't find a properly WAL under the $PGDATA/pg_xlog/ directory. Try to use pg_resetxlog