how to run multiple batch files in serial, in wind

问题:

I have a batch file,

bat1.bat
bat2.bat

but it stops at the end of bat1

any clues?

回答1:

Use call:

call bat1.cmd
call bat2.cmd

By default, when you just run a batch file from another one controll will not pass back to the calling one. That's why you need to use call.

Basically, if you have a batch like this:

@echo off
echo Foo
batch2.cmd
echo Bar

then it will only output

Foo

If you write it like

@echo off
echo Foo
call batch2.cmd
echo Bar

however, it will output

Foo
Bar

because after batch2 terminates, program control is passed back to your original batch file.

回答2:

This can happen if bat1.bat stops abnormally (other than just running to the end, like calling exit) and you can work around this by using a fresh cmd.exe to run each bat file:

start /b /wait bat1.bat
start /b /wait bat2.bat

You could omit it for the last one if there won't follow commands in you bat file.

回答3:

In order to run the multiple .exe files in one go, firstly you need to create .bat file and then add all of your .exe files as below:

  D:\Data\Feed.exe Books.xml
  D:\Data\Feed.exe Mobile.xml
  D:\Data\Feed.exe Clothes.xml

And then save as something.bat then give it a run with cmd.

回答4:

Something else to look for:

I had a similar issue where I was calling multiple batch files using the call command but it did not pass back the control to the original .bat file.

I found out that I had an exit command at the end of the batch file which closed the DOS window before going back to the original .bat file and finishing the commands there.

回答5:

If you want to run batchfiles in sequence you will have to put "start bat1.bat" at the end of each file.