How to plot a curved line in MATLAB using a set of

2019-09-19 23:48发布

问题:

I'm trying to draw ROC curves using an existing set of values using the following command

plot(X1,Y1,'--rs',X2,Y2,'-*g');

Where X1,Y1,X2 and Y2 are matrices that have the same size

However, the lines produced by this command are straight ones.

How can I make them curved lines.

Thanks Aziz

回答1:

MATLAB by default uses straight line approximation to draw your graph in between control points. If you want, you can interpolate in between the points to produce a more realistic graph. Try using interp1 with the 'spline' option and see how that goes. As such, figure out the minimum and maximum values of both X1 and X2, then define a grid of points in between the minimum and maximum that have finer granularity. Once you do this, throw this into interp1 and plot your curve. Something like:

%// Find dynamic range of domain for both Xs
minX1 = min(X1);
maxX1 = max(X1);
minX2 = min(X2);
maxX2 = max(X2);

%// Generate grid of points for both Xs
x1Vals = linspace(minX1, maxX1, 100);
x2Vals = linspace(minX2, maxX2, 100);

%// Interpolate the curves
y1Vals = interp1(X1, Y1, x1Vals, 'spline');
y2Vals = interp1(X2, Y2, x2Vals, 'spline');

%// Plot the results
plot(x1Vals,y1Vals,'--rs',x2Vals,y2Vals,'-*g');

linspace generates a grid of points from one end to another, and I specified 100 of these points. I then use interp1 in the way we talked about where you specify control points (X1,Y1,X2,Y2), then specify the values I want to interpolate with. I use the output values after interpolation and draw the curve.