Greenbone Community Edition (GCE) does not give re

问题:

I have installed the Greenbone Community Edition (GCE) ISO mentioned at installation in a virtual box in a Mint Linux with a bridged Adapter over WIFI in a home network. The IP that the virtual box got was 192.168.1.111.

Via advanced task wizard I started a new scan and after some sec it gave me the results:

Actually it didn't give any results.

What am I doing wrong? Should I do something further?

回答1:

The most common reason for this is that the target is not answering to an ICMP Echo Request which is the default method for deciding if a target is alive.

Please check the "Alive Test" setting of your Target definition (found via Configuration -> Targets) and try some of the other available methods like "TCP Service Ping" or even "Consider Alive".

One additional issue might originate from the initial sync of the NVT feed which could take up to one our or more. Without a fully synced feed (check the availability of the NVTs via SecInfo->NVTs) you also won't get any results.