Referring to my earlier question here, I've been utilizing tri-states to work with a common bus. I still appear to have some implementation issues.
The tri-states use this type of code:
assign io [width-1:0] = (re)?rd_out [width-1:0]:{width{1'bz}};
Synthesis and translation goes well. No warnings or errors I wasn't expecting (I was expecting some since this is only a trial run and most of the components don't do anything and will hence be left unconnected). But when I actually try to implement it, all busses (there are three) output a 1111111111111111, or a -1, as converted by my binary to BCD converter. I checked if it really the case by instructing the control matrix to halt if the instruction received on the bus is -1, and it did halt.
The warning I receive for the tri-state being converted to logic is:
Xst:2040 - Unit Neptune_I: 16 multi-source signals are replaced by logic (pull-up yes)
Xst:2042 - Unit alu: 16 internal tristates are replaced by logic (pull-up yes):
And so on. Neptune_I is the top module, and I believe the multi-source signals it's referring to are the busses.
I have a doubt whether the pull-up yes is the root of this problem. Is it simply pulling everything up, causing it to be -1 all the time? But this does not make sense to me, because when the tri-state is activated, the signal should be controlled by whatever entity it is supposed to be controlled by.
I would like to take the time to replace the code with logic instead of the tri-states, but I'm unsure how to proceed.
Any help would be appreciated.
